How to Clip Your Phone Anywhere with the HipClip Pocket Clip

By Nite Ize | Published: 2026-11-03

Category: How-to Guides

Stick the HipClip Universal Pocket Clip to your phone or case and carry it hands-free on a pocket, belt, or waistband. Follow these steps for a secure hold that lasts.

Quick answer

Stick the HipClip to the back of your phone or case with its 3M VHB adhesive, press firmly for a full minute, then slide the clip over a pocket edge, belt, or waistband. The low-profile clip holds your device hands-free without adding bulk.

Why a low-profile clip beats a holster or lanyard

A pocket clip keeps your phone accessible without the swing of a lanyard or the bulk of a belt holster. The HipClip is thin enough to leave on your device between uses, so you can move from desk to car to trail without re-rigging. The trade-off is that the adhesive is permanent once set, so placement matters more than with a removable mount.

When the clip is the wrong choice

If you change cases often or use a wireless charging pad daily, a clip stuck to the case may interfere. In those cases, attach the clip to a cheap second case you use for travel or outdoor days. Also skip clipping to thin athletic waistbands or loose pocket linings that can stretch or tear under the phone's weight.

Steps to set up and use the HipClip

Clean and dry the mounting surface: Wipe the back of your phone or case with an alcohol wipe and let it dry completely. Skip this and dust or oil will cause the adhesive to lift within days. Checkpoint: the surface should feel squeaky-clean and dry before you continue.
Test-fit the clip position: Hold the HipClip against the back of your phone or case without removing the adhesive backing. Aim for the clip to sit centered and low enough that the phone hangs balanced when clipped. A common mistake is placing it too high, which makes the phone tip forward.
Peel and press the adhesive: Remove the backing and press the clip firmly onto the surface for a full 60 seconds. Do not clip the phone to anything yet. The adhesive needs time to bond, and rushing this step is the most common cause of a clip that pops off. Checkpoint: wait at least an hour, ideally overnight, before putting weight on the clip.
Clip to a secure edge: Slide the clip over a pocket edge, belt, or waistband that fits snugly. Test by gently tugging the phone. If the fabric bunches or the clip slides, choose a thicker or tighter edge.
Adjust for comfort and access: Position the phone so the screen faces inward against your body for protection, or outward if you need quick glances. For travel, clip to a crossbody strap or backpack loop rather than a loose pocket. Checkpoint: make sure the clip is not pressing into your hip when you sit down.

Product facts

HipClip™ Universal Pocket Clip: The HipClip uses strong 3M VHB adhesive to secure the clip to a phone, multi tool, or accessory. That permanent bond means you should test-fit the clip's position before peeling the backing, because repositioning weakens the adhesive.
HipClip™ Universal Pocket Clip