How to Replace a CamJam Ratchet Strap Double Loop

By Nite Ize | Published: 2026-11-05

Category: Handleidingen

Swap a worn CamJam double loop strap in minutes. Follow these steps to remove the old webbing, thread the replacement, and tension cargo safely.

Quick answer

To replace a CamJam double loop strap, release tension, unthread the old strap from the ratchet and double-loop path, then feed the new replacement strap through the same route and test the ratchet before loading cargo.

Why the double loop matters for a safe swap

The double loop is the part that holds the strap tail and spreads load across the ratchet. If you thread the replacement strap incorrectly, the ratchet may not grip or the strap may slip under tension. Take a photo of the original routing before you remove it so you can match the path exactly.

When to replace rather than repair

Replace the strap when the webbing is frayed, cut, or stiff, or when the loop stitching is broken. A replacement strap is a low-cost fix compared with losing cargo. If the ratchet mechanism itself is damaged, a new strap alone will not solve the problem.

Step-by-step replacement

Release all tension: Open the ratchet completely and pull the strap tail out of the ratchet slot until the webbing is loose. Common mistake: leaving the ratchet under load, which can pinch fingers or damage the mechanism. Confirm the ratchet handle moves freely before you start unthreading.
Unthread the old strap: Follow the strap path through the double loop and ratchet, noting how it passes over and under each bar. Slide the old strap out completely. Checkpoint: take a photo before removal if the routing is unclear. Keep the old strap as a length reference for the new one.
Thread the new double loop strap: Feed the replacement strap through the double loop first, then through the ratchet slot following the same path as the old strap. Common mistake: skipping the double loop, which reduces grip and can cause slippage. Pull a few inches of tail through and check that the strap lies flat, not twisted.
Test the ratchet action: Close the ratchet and cycle the handle a few times without a load. The strap should advance and hold when you release the handle. Checkpoint: if the strap slips, recheck the threading path against your photo. A dry test run catches routing errors before you secure cargo.
Secure and tension cargo: Load your cargo, hook the strap ends, and ratchet until the strap is taut but not over-tightened. Common mistake: over-tensioning, which can crush light loads or stress the webbing. Checkpoint: press the strap; it should have slight give. Recheck tension after the first few miles of travel.

Replacement part

CamJam® Ratchet Double Loop Replacement Strap: Double-loop replacement strap designed for the CamJam Ratchet Strap System; available in multiple lengths. Choose the length that matches your original strap so the ratchet can take up the full tail without excess slack.
CamJam® Ratchet Double Loop Replacement Strap